Skip to content

speeduino/Ardu-Stim

Folders and files

NameName
Last commit message
Last commit date

Latest commit

 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 

Repository files navigation

Speeduino

Release License https://img.shields.io/discord/879495735912071269

This is the Speeduino fork of the ardustim engine simulator.

Ardu-Stim

Ardustim is an engine simulator built on the Arduino platform. It produces simulated crank and cam signals that can be used for testing aftermarket ECUs as well as being a useful tool for the development of firmware for these. It supports a large number of simulated rtigger patterns as well as multiple options for output speed (Eg Using an external pot, a fixed value or a sweep range)

Ardu-Stim Demo

This version is a fork of the original by David Andruczyk https://gitlab.com/libreems-suite/ardu-stim and is intended to provide a more modern, cross platform GUI as well as continued expansion of the trigger pattern library. It was primarily developed for use by the Speeduino community, but can be utilised for testing virtually any aftermarket ECU system

It is designed to run on an Arduino Nano, but will also work with Arduino Uno and Mega boards.

Wiring

  • Arduino Nano or Uno
    • pin 8 will provide the crank or primary wheel signal
    • pin 9 will provide the cam or secondary wheel signal
    • Pin 10 will provide a 2nd cam or tertiary wheel signal. This is for simulating some dual cam patterns
  • Arduino Mega
    • pin 53 will provide the crank or primary wheel signal
    • pin 52 will provide the cam or secondary wheel signal
    • Pin 51 will provide a 2nd cam or tertiary wheel signal. This is for simulating some dual cam patterns

Example for Arduino Nano connected to Speeduino v0.4 ECU:

Ardu-Stim Wiring

RPM Potentiometer

An optional potentiometer can be added to control the RPM value (With the relevant RPM mode selected). This should be connect to pin A0 if in use.

Installing and Using

Ardu-Stim is distributed as a ready-to-run binary for Windows, Mac (Intel and Arm) and linux (AppImage) so no installation is required. Simply down the latest release (https://github.com/speeduino/Ardu-Stim/releases/latest) and

First time Connection

The first time you connect Ardu-Stim to an Arduino Nano board, you need to upload the included firmware to it. Plug the Nano into your PC and then select the port from the list. Press the upload firmware button and wait for this to complete

Ardu-Stim Wiring

Note: This only needs to be performed with a new Arduino Nano or if upgrading from an earlier version. The automated uploading of firmware is ONLY available for Arduino Nano boards. If using another board you will need to manually compile and upload the firmware (Not the GUI)

Firmware Build

Optionally, the firmware source code can be built in either PlatformIO or the Arduino IDE and does not have any dependencies on 3rd party libraries that were used in the original version of Ardustim (Eg SerialUI)

Simply open the ardustim sub-folder in PlatformIO or the Arduino IDE and it should compile without issue.

Intended hardware platform is the Arduino Nano or Uno.

Installing GUI from Source

Pre-Requisites

GUI Installation steps

$ git clone https://github.com/speeduino/Ardu-Stim.git
$ cd Ardu-Stim/UI
$
$ npm install electron-rebuild -g
$ npm install
$ npm start