Automatic-Pet-Feeder

This project is an automatic pet feeder, designed to make pet care easier and more convenient.
Note: This project is in active development and not yet fully tested and functional.

Structure

The project is divided into two main parts:

1. 3d-models - This folder contains all the 3D models used in the project. These models are used to create the physical structure of the pet feeder, following the assembly.

2. code - This folder contains the MicroPython code that runs on a Raspberry Pi Pico. The code controls the weight sensor and the servo that deploys the food. It also runs a web server, allowing remote access to the device.

Hardware

• Raspberry Pi Pico
• Weight sensor
  • HX711 load cell amplifier
  • Load cell 5kg
• Servo motor MG995

Software

The software is written in MicroPython and runs on a Raspberry Pi Pico. It uses a weight sensor to determine when to dispense food and a servo motor to deploy the food. The software also includes a web server, allowing remote access and control of the device.