BH1750.h

/*

This is a library for the BH1750FVI Digital Light Sensor
breakout board.

The board uses I2C for communication. 2 pins are required to
interface to the device.

Datasheet:
http://rohmfs.rohm.com/en/products/databook/datasheet/ic/sensor/light/bh1750fvi-e.pdf

Written by Christopher Laws, March, 2013.

*/

#ifndef BH1750_h
#define BH1750_h

#if (ARDUINO >= 100)
#include <Arduino.h>
#else
#include <WProgram.h>
#endif
#include <Wire.h>

#define BH1750_DEBUG 0

#define BH1750_I2CADDR 0x5C
// That value should be default in case you didn't connect ADD pin, but
// for some reason in my case secondary address (0x5C) was used by default
//#define BH1750_I2CADDR 0x23


// No active state
#define BH1750_POWER_DOWN 0x00

// Wating for measurment command
#define BH1750_POWER_ON 0x01

// Reset data register value - not accepted in POWER_DOWN mode
#define BH1750_RESET 0x07

// Start measurement at 1lx resolution. Measurement time is approx 120ms.
#define BH1750_CONTINUOUS_HIGH_RES_MODE  0x10

// Start measurement at 0.5lx resolution. Measurement time is approx 120ms.
#define BH1750_CONTINUOUS_HIGH_RES_MODE_2  0x11

// Start measurement at 4lx resolution. Measurement time is approx 16ms.
#define BH1750_CONTINUOUS_LOW_RES_MODE  0x13

// Start measurement at 1lx resolution. Measurement time is approx 120ms.
// Device is automatically set to Power Down after measurement.
#define BH1750_ONE_TIME_HIGH_RES_MODE  0x20

// Start measurement at 0.5lx resolution. Measurement time is approx 120ms.
// Device is automatically set to Power Down after measurement.
#define BH1750_ONE_TIME_HIGH_RES_MODE_2  0x21

// Start measurement at 1lx resolution. Measurement time is approx 120ms.
// Device is automatically set to Power Down after measurement.
#define BH1750_ONE_TIME_LOW_RES_MODE  0x23

class BH1750 {
 public:
  BH1750();
  void begin(uint8_t mode = BH1750_CONTINUOUS_HIGH_RES_MODE);
  void configure(uint8_t mode);
  uint16_t readLightLevel(void);

 private:
  void write8(uint8_t data);

};

#endif