Firmware update with ethLoader and canLoader #91
-
Hi, |
Beta Was this translation helpful? Give feedback.
Replies: 5 comments
-
Hi, for the EMS yes, you can tick all the boards, since the firmware is the same (ems.hex) for all of them. |
Beta Was this translation helpful? Give feedback.
-
@randaz81 thanks, but in the canLoader there is also only one 2FOC.hex, skin.hex and strain.hex file, is it not possible, for example on the board 10, check all the boxes and load the skin.hex at once? |
Beta Was this translation helpful? Give feedback.
-
yes you can load in one shot all the skin parts (with skin.hex) |
Beta Was this translation helpful? Give feedback.
-
Thanks @julijenv. |
Beta Was this translation helpful? Give feedback.
Hi, for the EMS yes, you can tick all the boards, since the firmware is the same (ems.hex) for all of them.
For the canLoader, it's possible (in principle). However, except for the strain board (strain.hex), all the other boards have different firmware types.