-
After successful ESC calibration tunes, Bolt 1.1 is unable to execute any setpoint commands through a joystick/cfclient interface or high level commander setpoints (after enabling the high-level commander). I tried running firmware versions 2022.09, 2022.05, and 2022.03 but had the same issue. Older firmware versions <2022.03 which ran perfectly well for me on Bolt 1.0 don't seem to work on Bolt 1.1. On flashing firmware version 2021.06, Bolt 1.1 doesn't startup normally, only the blue LED near M2 turns on and I'm not able to connect to the Bolt. I tested the motors using the Looking at I never faced this issue when using Bolt 1.0 with firmware version 2022.01, the drone was able to execute commands as soon as the battery was connected. Since I'm able to send power to the motors using the I'm using the following ESCs with the Bolt: Here's the console output on startup:
|
Beta Was this translation helpful? Give feedback.
Replies: 1 comment
-
Ah nevermind, turns out it was an issue with the custom c++ CRTP library I'm using. |
Beta Was this translation helpful? Give feedback.
Ah nevermind, turns out it was an issue with the custom c++ CRTP library I'm using.