Anyone can share 0.6mm nozzle profile?

[Trilis29]

I am looking for PS or Orca profile for 0.6mm nozzle, maybe someone could share? :)

[bassamanator]

The bundle on this repo should be parametric, so adjusting nozzle size to 0.6 should be all that is required.

[Trilis29]

extrusion width parameters are non percent based, so these won't change by changing the nozzle only or I miss something?

[bassamanator]

You're right, the PS settings are not percent based, but the SS settings are.

Shouldn't be too hard. Duplicate the Print settings profile you want to use, then convert the mm based values to percentages keeping in mind that these values are for a 0.4mm nozzle.

[JoernSchoenyan]

@Trilis29 what is your solution? If you didn't tinker around with it, I would volunteer to port the settings over to OrcaSlicer.

[JoernSchoenyan]

@bassamanator right now, there is a bug in Orcaslicer which prevents exporting the printer profile - when this is fixed, would you accept a pull request with a Orca profile?

[JoernSchoenyan]

My current speed values:

But now, my bed thermistor is faulty, I think the cable is broken as it goes wild when moving. Need to investigate further.

[dweenz]

you can simply run 2 new wires to test. There have been a few people with this issue.

[JoernSchoenyan]

New wires did the trick.

[Trilis29]

@JoernSchoenyan could you upload your config?

[JoernSchoenyan]

The bug in OrcaSlicer isn't fixed yet, so I can't export the profile.