You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
{{ message }}
This repository has been archived by the owner on Jan 6, 2023. It is now read-only.
On first boot I did the load filament thing, it said heating extruder but nothing happened. There was a picture showing red lights but the lights never came on. After 5 minutes I gingerly touched the hot end and it was cold. After a reboot the lights came on and the hot end did heat.
One issue is that to go wrong the first time it's turned on is a bad first impression.
Secondly it's not even clear when it has gone wrong - the screen was working fine, there was no message to say anything was wrong, but the lights and heat didn't come on.
The text was updated successfully, but these errors were encountered:
Sign up for freeto subscribe to this conversation on GitHub.
Already have an account?
Sign in.
On first boot I did the load filament thing, it said heating extruder but nothing happened. There was a picture showing red lights but the lights never came on. After 5 minutes I gingerly touched the hot end and it was cold. After a reboot the lights came on and the hot end did heat.
One issue is that to go wrong the first time it's turned on is a bad first impression.
Secondly it's not even clear when it has gone wrong - the screen was working fine, there was no message to say anything was wrong, but the lights and heat didn't come on.
The text was updated successfully, but these errors were encountered: