You signed in with another tab or window. Reload to refresh your session.You signed out in another tab or window. Reload to refresh your session.You switched accounts on another tab or window. Reload to refresh your session.Dismiss alert
I did the UART connection and checked the output and succesfully got the Key (not the Token), based on [methods detailed in 1166]. This allowed me to ADD it to AlexxIT's Gateway 3 interface. In fact I did two of them. (#1166).
My question however is about the need for telnet following integration; I can access the Gateway menu using Putty, but no Admin/Password pair matches, so I cannot actually log in. I tried admin/admin, admin/blank, admin/123123 and a few other combinations. I tried the 5-2-2-2-2-2-2 setting.
Do I need telnet access for anything in future?
If yes, is the only way to use UART, then downgrade the FW; and then strip out the password, so if I upgrade it again, it is blank? Is this possible and will blank password this be "sticky" if I upgrade the FW again?
Is there actually some way to get Full Telnet Access using the Token+Key (which I now have saved) for each device?
Thx
The text was updated successfully, but these errors were encountered:
I have a ZNDMWG04LM with 1.07_0019 FW.
I did the UART connection and checked the output and succesfully got the Key (not the Token), based on [methods detailed in 1166]. This allowed me to ADD it to AlexxIT's Gateway 3 interface. In fact I did two of them. (#1166).
My question however is about the need for telnet following integration; I can access the Gateway menu using Putty, but no Admin/Password pair matches, so I cannot actually log in. I tried admin/admin, admin/blank, admin/123123 and a few other combinations. I tried the 5-2-2-2-2-2-2 setting.
Thx
The text was updated successfully, but these errors were encountered: